dopaprofessionals.blogg.se

Remote control software provides a user interface, similar to the radio's front panel, and allows you to control the radio from a remote location. With this interface, you will be up and running on PSK31, SSTV, Pactor, Packet or any mode that requires CAT control and Tx/Rx Audio Interfacing between your PC Soundcard and Radio within minutes. System configuration software sets up IP address, audio sampling rate and other settings.Ģ. The RS-BA1 Windows® CD consists of two component software applications:ġ. Shown above in use with a dual-receive transceiver. The RS-BA1 Version 2 can also still be used with single-receiver transceivers. The RS-BA1 Version 2 can also enlarge the panel size (normal or large is selectable), buttons added, clickable indicators to change settings, SUB dial added and RIT tuning knob & TX functions added. With the RS-BA1 Version 2, you can use the dual watch operation and spectrum scopes with waterfall function as well as observe the MAIN and SUB spectrum scopes. The S-Meter and SWR can even be observed. Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio. Most functions and modes of your Icom compatible transceiver can be controlled, including interference rejection functions and IF filter settings. If anyone has any suggestions, I would appreciate any comments or help offered.The Icom RS-BA1 v2 IP Remote Control Software allows you to use an Icom compatible radio installed in another room using your home network or even from a remote location over the Internet.

#RS BA1 COMPATIBILITY DRIVER#

Both PCs are running 64-bit Win10 Pro and the driver that came with the software is reported to be Win10 compatible so, I am baffled. The server PC is connected to the radio via a USB cable. I have not yet tested the transmit audio, as I want to get the receive side working first. It behaved exactly the same way, whereas when he remotely controls his IC-7610, it behaves properly (i.e., AF level adjustments made on his remote PC, adjust the PC audio level, not the radio's own audio level - controlling the radio volume instead of the PC volume What's even more bizarre is that, when adjusting the AF knob within the Remote Control app on the remote PC, I am actually adjusting the volume emanating from the radio's own speaker! In other words, it is behaving the opposite of the way in which it should.Īs a test, a local ham permitted me to remotely access and control his IC-7610.

I cannot control it by rotating the AF knob within the Remote Control app window on the computer, nor can I control it via the PC's own volume controls.

HOWEVER, there is a serious problem, namely that I cannot control the receive audio volume coming out of the laptop. Of course, the RS-BA1 can be used with Icom single receiver. MAIN and SUB spectrum scopes can be observed on the RS-BA1 at the same time. I can hear the receive audio on my office PC and I can control the radio in every way I have tried (band changes, frequency tuning, mode changes, filter selection, etc. RS-BA1 RS-BA1 PC (Remote) USB (CI-V + audio) PC (Base Server) IC-7300, IC-7100 RS-BA1 RS-BA1 The dualwatch operation and dual spectrum scopes with the waterfall functions can be used on your remote PC. As the dusty project will be ending soon, I have now unboxed the IC-7300 in my upstairs office where I updated the radio firmware to v1.30 and also installed the RS-BA1 v1.96 software on two HP laptops, one as the server PC and the other (my main office laptop) as the remote PC. I have had an IC-7300 and the RS-BA1 software for quite some time, but both sat unused in the box on a shelf until recently because of other priorities and a very dusty granite rock removal project being underway in the basement where my antennas terminate.